Fault F233 (freestanding appliance)

Remove and dismantle the parts of the central spout. Reassemble the parts in the right order and reinsert them.

Proceed as follows:

• 

• Carefully pull the stainless steel cover forward and off.

• 

• Pull the dispensing unit forward to remove it.

• 

• Twist off the upper section  with the holder for the milk pipework. Pull the component off.

• Then pull the Y-shaped piece  off.

• Remove the spouts .

• Important during reassembly:

  Ensure the spouts are placed onto the dispensing unit with the lug facing back.

  Make sure that all parts are tightly connected to one another.

• 

• Fit the dispensing unit back together as follows:

• Push the spouts  firmly back onto the dispensing unit.

• Refit the Y-shaped piece .

• Refit the upper section  with the holder for the milk pipework. Turn the component.

• Refit the dispensing unit in the central spout.

• Refit the stainless steel cover.

Replace the cup rim sensor, proceeding as follows:

• 

• To remove:

  • Press the two latches together, see figure.

  • The cup rim sensor is released.

• To refit:

  • Press the cup rim sensor from below into the holder on the central spout.

Please contact the Miele Customer Service Department to order a new cup rim sensor.