The milk froth is not hot enough or is too runny.
Good milk froth can only be achieved with cold milk (< 10 °C).
Milk is not cooled in the milk container. Therefore, place the milk container in the refrigerator if you are not going to use milk for a while.
Cool your milk in the refrigerator until it is below 10 °C.
Clean and fit the central spout and milk container lid as described in the operating instructions for your coffee machine.
An elbow connector for the milk pipework is included in the scope of delivery of the coffee machine as a spare part.
Replace the old elbow connector with the elbow connector supplied. Proceed as follows:
Open the appliance door.
Open the service flap on the back of the appliance door.
First remove the air intake hose (1) from the opening (3). Then pull off the elbow connector (2).
Pull both hoses off the elbow connector.
Clean the air intake hose (1) under running water using the cleaning brush supplied. Blowing through the hose can also loosen any blockages.
Insert the cleaning brush into the milk pipework (4). Move the cleaning brush forwards and backwards as far as possible until all milk residue has been removed.
Now take the new elbow connector. (You can dispose of the used elbow connector in your household waste.)
Push the hoses onto the elbow connector and reinsert it. Make sure that the bar on the elbow connector is pointing downwards. The tubes must fit firmly on the elbow connector and form a tight seal.
Insert the air intake hose back into the opening (3).
Refit the service flap.
Close the appliance door.
