The programme is taking much longer to complete. Fault messages are being displayed for the AutoDos system and/or the programme running time has increased by 2 hours. The wash results might be unsatisfactory because no detergent has been dispensed. In this case, the AutoDos function is automatically deactivated during the programme sequence.
The advertising insert has not been removed.
A PowerDisk has not been inserted, possibly because the customer has assumed that the advertising insert is in fact the PowerDisk.
AutoDos has been activated.
Remove the advertising insert.
Insert a PowerDisk.
Run the programme including the additional 2 hours.
A residual amount of powder is always left behind in the PowerDisk.
PowerDisks should be replaced in good time.
Run the programme including the additional 2 hours.
Insert the fill channel again.
Run the programme including the additional 2 hours.
As a result, the appliance is permanently detecting the status as “PowerDisk inserted”, even though a PowerDisk has not been inserted.
AutoDos is not being deselected automatically after closing the lid.
Release the lever, see figure.
Run the programme including the additional 2 hours.
The last dose from the dispensing reserve is being signalled correctly but the fact that the reserve is empty is not being detected and the programme is ending without a fault.
The display then shows Problem with AutoDos in the next programme.
Replace the PowerDisk.
Run the programme including the additional 2 hours.
The PowerDisk was dispensed empty in the last programme completed. The fact that it was empty was detected correctly.
If the programme is subsequently interrupted manually (with AutoOpen, for example), AutoDos is not deselected automatically.
If the dishwasher is then emptied immediately and refilled with dirty crockery and started again, the fact that the PowerDisk is empty is not being detected before the next programme sequence.
After the programme has started, the display shows Problem with AutoDos.
Replace the PowerDisk if it is empty.
Run the programme including the additional 2 hours.
Clean the fill channel.
Clean the spray arms.
Run the programme including the additional 2 hours.
