The stopcock is not open.
Terminate the wash programme.
Open the stopcock.
Select the programme and start it again.
Support for yourWashing Machine
Fault F10
Fault F10 is shown on the display of the washing machine/washer-dryer. The water inlet is blocked or restricted.
The inlet filter is soiled.
Clean the inlet filter:
First turn off the stopcock.
Unscrew the water inlet hose from the stopcock.
Remove the rubber seal (1) from the recess.
Hold the free end of the water inlet hose upside down.
The plastic filter (2) will fall out.
Clean the inlet filter.
The inlet filter must be put back in place after cleaning.
Reassemble in reverse order.
Turn on the stopcock and check that the connection is watertight.
If water drips out, tighten the connection.
Additional information can be found in the linked video.
The water inlet hose is kinked.
Remove any kinks or loops from the water inlet hose.
Keep an eye on these points for a while afterwards, as the plastic may weaken and tear. In the event of any damage, the water inlet hose must be replaced. Please contact the Miele Customer Service Department.
The water connection pressure in the water supply pipe is too low.
With the stopcock fully open, at least 5 l of water should flow from it within 15 s.
Contact the facility manager or a plumber.
The water connection pressure in the water supply pipe is too low and cannot be increased.
If the fault persists, please contact us or book a repair appointment online.
Additional media
Operating Instructions finder
Here you will find the operating instructions for your Miele appliances
Find your manual
